![]() The control horns were scaled down (75%) from these: . I covered the wings with packing tape and used foam plates to cut out winglets that I drew freehand. I was able to print each wing diagonally on my Monoprice Maker Select 3d v2.1 printer that has a 200mm build plate. The assembled wing is 40cm (400mm) using 2 printed parts. Use the files as specified below. #Tinkerfun It is likely too large to print on one print bed. The flying wing with fpv stl file is for demonstration only.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |